November 2026 · 5 min read · By Adam Schlichting, co-founder and lead installer
Quick answer
Good window film, professionally installed on the inside of the glass, is made to stay on for decades. Most XPEL VISION interior films for homes carry XPEL’s limited lifetime warranty (commercial and exterior films have shorter terms), and every Film Bros installation comes with our own 35-year installation warranty against bubbling, fading, yellowing and peeling. How long yours actually lasts comes down to the film, which side of the glass it is on, how much sun it gets and how it is cleaned.
We remove a lot of old film before we install new film, so we see what failure looks like up close: purple tint, bubbles, peeling corners and film that comes off in flakes. Almost all of it traces back to the same few causes. Here is what decides how long film lasts, the signs it is time to replace it, and what the warranty really covers.
What decides how long window film lasts
- The film itself. Cheap dyed films get their colour from dye, and sunlight breaks dye down over time. That is why old film turns purple or brown and starts to look blotchy. Quality films are built to hold their colour and clarity for the life of the warranty.
- Inside or outside the glass. Interior film is protected from rain, snow, ice and road grime, so it lasts far longer. Exterior film takes the weather every day, which is why exterior films carry shorter warranties. We put film on the inside whenever the glass allows it.
- Sun. South and west windows get the most heat and UV, so they are where a poor film fails first.
- The install. Film lasts when the glass is cleaned properly, the edges are cut tight and every bit of water is pushed out. Dust, hair or a lifted corner on day one becomes a bubble or a peeling edge later.
- How it is cleaned. Ammonia cleaners, gritty paper towels, scrapers and razor blades all wear through the film’s scratch-resistant top layer.
Signs your window film needs replacing
- Purple or brown tint that was not there when it went on.
- Bubbles or blisters that show up months or years later. (A light haze or small water pockets in the first few weeks is normal while the film cures, and it clears on its own.)
- Peeling or lifting edges, especially at the bottom of the window where condensation sits.
- Cracking, crazing or haze that makes the view look cloudy.
- Scratches deep enough to catch the light.
Old film does not fix itself, and it gets harder to remove the longer it bakes in the sun. Our guide on how to remove window film shows how to take it off without scratching the glass, or we can remove it and put new film on in the same visit.
What the warranty covers
There are two warranties on a Film Bros job, and they cover different things.
- The film maker’s warranty. Most XPEL VISION interior films for homes carry XPEL’s limited lifetime warranty against defects such as yellowing, cracking, blistering, peeling and delaminating. Commercial and exterior films have shorter terms. When the film is professionally installed, XPEL’s limited warranty can also extend to seal failure on double-pane units (as long as you have a valid seal warranty from your window maker), and glass breakage from heat stress is covered up to $500 per window.
- Our installation warranty. Every Film Bros installation comes with a 35-year warranty against bubbling, fading, yellowing and peeling.
Both depend on the film being professionally installed and cared for, so keep your receipt. The full terms are on our warranty page.
How to make window film last
- Leave it alone while it cures. Do not clean or touch the film for the first few weeks. We tell you exactly how long before we leave.
- Clean it gently. A soft microfibre cloth or a clean rubber squeegee with mild soapy water is all it needs.
- No ammonia, no grit, no blades. Skip glass cleaners with ammonia, gritty paper towels, scrapers and razor blades.
- Nothing stuck to the film. Tape, stickers and suction cups can lift or mark it when they come off.
- Watch the bottom edge. If condensation pools on the sill in winter, wipe it dry so the film edge is not sitting in water.
Questions people ask
How long does window film last on a house?
Quality film installed on the inside of the glass is made to last for decades. Most XPEL VISION interior films for homes carry a limited lifetime warranty, and every Film Bros install has our 35-year installation warranty against bubbling, fading, yellowing and peeling.
Why does old window film turn purple?
Many older and low-cost films get their colour from dye. Sunlight breaks the dye down over the years, and what is left looks purple or brown. Films built to hold their colour do not do this, which is one reason the warranty matters more than the price per roll.
Does exterior window film last as long as interior film?
No. Exterior film takes rain, snow, ice and cleaning from the outside, so it wears faster and carries a shorter warranty. We install on the inside of the glass whenever we can.
Will window film void my window warranty?
Check your window maker’s warranty first. When XPEL VISION film is professionally installed, XPEL’s limited warranty can extend to seal failure on double-pane units, as long as you have a valid seal warranty from your window maker, and heat-stress breakage is covered up to $500 per window. We check your glass against XPEL’s film-to-glass chart before we recommend a film.
Can old film be replaced?
Yes. Old film is peeled, the glue is cleaned off, and new film goes on the clean glass, often in the same visit. See what it costs in our window film cost guide.
Want film that lasts? Book a free call with Josh and send a photo of your windows, or text a photo of your old film and we will tell you if it needs replacing.
