Install guide
How to install window film yourself
The same wet-apply method our installers use on every job across the GTA. Most windows take 15 to 30 minutes. Read it once before you start, then keep it open beside you.
Stuck at any point? Text a Film Bros installer at (647) 260-9544 with a photo of the window. We answer as fast as we can.
What you need
- Your film pieces (each custom piece is labelled with the window name you gave it)
- The squeegee, spray bottle, application solution and snap-off blade from the kit
- Clean water, lint-free paper towels and two small pieces of tape
- A razor scraper for glass (optional, for paint specks and stuck-on dirt)
Mix the solution as the packet says: a few drops in a full bottle of clean water. Too much soap and the film takes longer to grab; too little and it is hard to slide into place.
Before you start the check
- Work out of direct sun. The solution dries too fast on hot glass.
- Above 5°C is best. In winter, install on a mild day or warm the room first.
- Our DIY films go on the inside of the glass.
- Planning reflective or solar film on glass that is already tinted, cracked or very large? Text us first so we can check the glass type.

Step by step
- Unroll and check your pieces. Match each label to its window and let the film relax flat for a few minutes.
- Clean the glass like you mean it. Spray, scrape any specks with the razor scraper, squeegee dry, then spray and squeegee once more. Wipe the frame and the rubber gasket too: dust there ends up under the film.
- Wet the glass. Spray the whole pane until it is dripping. You cannot use too much.
- Peel the liner. Stick a piece of tape on each side of one corner and pull them apart. Peel the clear liner off slowly while spraying the sticky side of the film as it comes away.
- Place the film. Lay the wet, sticky side on the wet glass. Slide it into place so it overlaps the glass a little on every edge (that is the 1/4" extra we cut on).
- Spray the front of the film. This lets the squeegee glide without scratching.
- Anchor it. Squeegee once from the centre straight up, then from the centre out to each side, then down. Overlap every stroke and press firmly.
- Trim the edges. Hold the edge of the squeegee or a stiff card against the frame and run the blade along it, leaving a gap of about 1/16" (1.5 mm) between the film and the frame. Snap off a fresh blade tip for every window: a dull blade tears film.
- Final squeegee. Spray again, then push the remaining water out to the edges with firm strokes. Wrap a paper towel around the card and press along all four edges to soak up the last drops.
Film by film
Frosted privacy
The easiest film to install. It hides small specks, so it is a great first project.
Silver and dual reflective
Reflective film shows every speck of dust, so clean twice and work in a clean, still room. Remember the mirror effect works by day: at night with lights on inside, people can see in.
Clear premium solar
Clear film shows dust and fingerprints most, so wash your hands and clean the glass three times. A soft haze for the first days is normal.
Clear safety film, 4 mil and 8 mil
Thicker film is stiffer. Use more solution, press harder with the squeegee and expect a longer drying time, especially in cold weather.
Drying time and care
- Small water pockets and a light haze are normal. They dry out on their own in 2 to 4 weeks, longer in winter.
- Do not clean the film or roll blinds tightly against it for 30 days.
- After that, clean with a soft cloth and a mild soap and water mix. No ammonia, no paper towels with grit, no scrapers on the film.
Quick fixes
- A bubble with air in it: spray the film and push the bubble to the nearest edge with the squeegee.
- A speck of dust under the film: while it is still wet, lift that corner, rinse the speck off with the spray and lay it back down.
- An edge lifting: press it again with the towel-wrapped card. If it keeps lifting after a day, the edge was too close to the frame: trim a hair more.
- A piece does not match your order size: text us a photo. If we cut it wrong, we recut it free under our recut guarantee.
Rather have it done for you? Our installers work across the GTA every day, and if you bought your film from us in the last 30 days, what you paid goes toward the install. Get a free plan.